Details

---

X’BOND CONSTRUCTION ADHESIVE SEALANT IS A CONSTRUCTION PANEL ADHESIVE AND SELANT THAT WILL NOT SLUMP ON VERTICAL SURFACES. IT HAS BEEN FORMULATED TO BOND TO A WIDE VARIETY OF CONSTRUCTION MATERIALS INCLUDING PVC, WOOD, GYPSUM BOARD, CONCRETE, MASONRY, ALUMINIUM, GALVERNISED IRON, STEEL, FIBROUS CEMENT SHEET AND FLOOR PANELING. XBOND IS ALSO SAFE TO USE ON FOAMED POLYSTYRENE AND MIRROR BACKED TILES.

USES:

- BONDING PVC, WOOD, GYPSUM BOARD, CONCRETE, MASONRY, ALUMINIUM, GALVERNISED IRON, STEEL, FIBROUS CEMENT SHEET AND FLOOR PANELING.
- BONDING FOAMED POLYSTYRENE, POLYURETHANE AND MIRROR BACKED TILES.
- SEALING GAP FOR VARIETY OF CONSTRUCTION MATERIALS

SPECIFICATION:

- APPEARANCE : BEIGE PASTE.
- ODOUR : AROMATIC ODOUR
- SPECIFIC GRAVITY :1.15 ± 0.05
- SOLID CONTENT : 76% APPROX.
- VISCOSITY : 180,000 CPS @ 25ºC, #7, 20 R.P.M. APPROX.
- LAP SHEAR : 146PSI (COTTON BACKED PVC TO STEEL, 1 MINUTE OPEN TIME AND CONDITIONING FOR 24 HOURS AT 20°C)
- APPLICATION TEMP.: -10°C TO 30°C
- SERVICE TEMPERATURE: -10°C TO 85°C
- SHELF LIFE: 12 MONTHS

APPLICATION INSTRUCTIONS:

X’BOND CONSTRUCTION ADHESIVE SEALANT CAN BE APPLIED EITHER BY 1-WAY WET STICK ADHESIVE METHOD OR 2-WAY CONTACT METHOD. IN BOTH CASES THE FIRST REQUIREMENT IS THAT BOTH SURFACES TO BE BOND MUST BE CLEAN, DRY AND FREE OF GREASE, OIL AND DUST. ANY LOOSE OR FLAKING PAINT MUST BE REMOVED AND LIGHTLY SAND BEFORE APPLICATION.

CURING TIME: X’BOND CONSTRUCTION ADHESIVE SEALANT WILL BOND IN APPROXIMATELY 7-24 HOURS IN ROOM TEMPERATURE. THE CURING TIME MIGHT BE LONGER FOR SMOOTHER SURFACES.